fbpx

Compatibility

Boat Compatibility

BoatCompatible?Exceptions
Carl Douglas Racing ShellsYes, with flat foot board fitted
EmpacherYesBoats with the very old White Adidas shoes will not fit standard but the drill pattern can be adjusted or a new compatible foot plate can be fitted. The template needed is attached below.
EuroDiffusionsYes
Filippi BoatsYesBoats with the White Adidas shoes will not fit standard but the drill pattern can be adjusted or a new compatible foot plate can be fitted. The template needed is attached below.
FluidesignYesWhen fitting, start with one screw, not fully tightening it, and then start the other 3, tightening each slightly, until all 4 are in.
Hudson Boat WorksYes (standard fitment in all shells since 2011)
JanousekYes
KaschperYes – with the standard offset 4 hole drill pattern.
KanghuaYes – with the standard offset 4 hole drill pattern.
LevatorYes – with the standard offset 4 hole drill pattern.
Martinoli SRLYes - all boats fitted with the standard Martinoli shoes
NeloYes
Pocock Racing ShellsYes
Race 1Yes – with the standard offset 4 hole drill pattern.
Resolute Racing ShellsYes
SalaniYes
Stampfli Racing BoatsYes – All boats excluding those fitted with White Adidas shoes.Boats with the White Adidas shoes will not fit standard but the drill pattern can be adjusted or a new compatible foot plate can be fitted. The template needed is attached below.
Swift RacingLatest versions Yes - with the standard 4 hole drill pattern foot board.
No for the older Swift drill pattern. Replacements through Swift possible
Will not fit the standard square Swift foot plate drill pattern but this can be adjusted or a new compatible foot plate can be fitted.
Sykes RacingYesThe QuickRelease System works with Sykes steering seats, however a small adjustment is required. Contact Sykes or [email protected]
Van DusenYes – with flat foot board fitted only for the QuickRelease System.The CustomPack will fit on the Van Dusen curved foot board, QuickRelease system will not.
VespoliNo, when fitted with standard Vespoli or VHP shoes.
Yes - with offset 4 hole drill pattern foot board only. The pattern used by almost all other shoes
Will not fit boats with standard drill pattern and Vespoli/VHP shoes. This can be adjusted or Vespoli have a compatible foot plate
WinTech RacingYes – with the standard offset 4 hole drill pattern.The older and more standard (cheaper) Wintech shoes use an M6 bolt that will not fit in the ShoePlate Top.

Shoe Compatibility

ShoeCompatible?Exceptions
AgainstYes
Empacher (Against)Yes
Nike OmadaYes
Project B shoesYes
JL Sport DEYes
PocockYes
SykesYesOn Shoes up to size US10, follow the same process as on instructions. For large shoes, line up top 2 holes along with one of the bottom holes. Screw in top 2 screws and then first bottom one. Move ShoePlate Top to allow for last screw to be screwed in. (Shoe will adjust)
H2RowYesOn some models, when fitting, start with one screw, not fully tightening it, and then start the other 3 (in a diagonal fashion), tightening each slightly, until all 4 are in.
FilippiYesRemove the angle piece on forefoot of the shoe to ensure optimal angle
AdidasYesAll except the White model with green neoprene case. The white model of 2009-2011 will not fit, the black model will sit lower down the SPPQR but still function well
WintechYesThe new (2018+) Wintech Shoes fit very well. Much older Wintech shoes with the M6 screws do not fit
NewWaveYesSome of the pre-2014 models may overhang the ShoePlate Top when larger than size 13 but should still function well.
MartinoliYes* Sizes over 13 may overhang the ShoePlate Top but function should still be ok. If you feel the foot rolling/instability then the shoe is likely too large for the ShoePlate Top.
Vespoli VHPNo
Swift own brandNo

Click to Download the Drill pattern PDF Template.

Instagram

  • The GOAT boat! Who else wishes they could row with the Silver Fern?
  • Glassy sessions are always the most memorable! #repost thanks @dietz.rowing 📸@williamhuber
  • #Repost @simon_vandorp "Starting to miss this..." Could not agree more, bring on Tokyo 2021!

#stayathome #socialdistancing
  • Sending our thoughts to everyone around the world as we are all currently affected in so many ways by COVID-19. We wish for you all to be safe in this uncertain time. 
It appears almost certain that the Tokyo Olympic Games will be postponed. We would like to extend our encouragement to Rowers at all levels that have had their respective competitions and training cut short. We hope this clip of the GB Men’s four Rio Olympic win, reminds you all of the amazing things we as Rowing lovers have to look forward to once these hard times are overcome.
  • @westendrc came away with the goods this past weekend at the NZ National Championships with 4 x🥇 3 x 🥈 and 4 x 🥉. A great result from the 21 rowers in the squad. West End RC are a fully fitted BAT Logic QuickRelease club based in Auckland.
#Repost 📸 @rowingcelebration
  • WOW! What a morning, who wouldn
  • NZ Rowing Championships has arrived! 
#Repost @nyacrowing
• • • • • •
Lake Karapiro

Game time! Last training session today on Lake Karapiro and racing kicks off tomorrow as three NYAC athletes compete at the New Zealand Championships  #Repost @nyacrowing
• • • • • •
  • That
  • Belgium Lwt Double getting psyched up prior to their successful qualification race for #tokyo2020. Best of luck with your road to Tokyo @niels_van_zandweghe @timbrys !

Sign up to our Newsletter

Stay Connected

Terms & Conditions

© 2019 All Rights Reserved BAT Logic